# Fridge Supervision Application

## Instructions

The first time executing the app, you must click on Reset and few seconds after on Learning. This will make the application adapt to your installation. Also you will have to fill in once the dSM circuit [0...] field and the desired mail address to receive the notifications

1. Reset Button: Clicking this will erase any parameters measured so far by the application. It must be done the first time, and every time your installation (devices, fridges, refridgerators) change. It can be optionally used to deal with unexpected behaviors, that may have occured by having the app run the learning process on unusual data.
2. Learn Button: Clicking this will trigger the app to take into account the last 12hours of fridge operation and adapt to it, considering it as normal behavior. Clicking this again without reseting old parameters, will result to taking the average of this calculation and the existing parameters. It is adviced to click it only if the past 12 hours of your fridge do not contain any irregular events (plug-off, open door) and it is important to have it clicked at least once after the device has performed a defrost, if the device is set to perform a scheduled one regularly.
3. Detect Button: Clicking this will force the app to run and detect if the current behavior of the fridge is acceptable or not, comparing to the data learned

## Control Panel

Choose action: |  |  |  |

Choose dSM Circuit #: |  |
Choose receiver mail address: |  |

Last On-Time: |  | minutes.
Last Off-Time: |  | minutes.

## Current Parameters

If Maximum Consumption appears to be -1, it means that two fridges have been detected in your installation. Please ignore all parameters except for the 3 Levels. In other case, the parameters are valid and the 3 levels are the ones to be ignored.

Last Run Detection: |
Minimum Consumption to be accepted: |  | watts.
Maximum Consumption to be accepted: |  | watts.
Minimum OnTime to be accepted: |  | minutes.
Maximum OnTime to be accepted: |  | minutes.
Minimum OffTime to be accepted: |  | minutes.
Maximum OffTime to be accepted: |  | minutes.
Lower Consumption Level (for 2 fridges): |  | watts.
Mid Consumption Level (for 2 fridges): |  | watts.
Higher Consumption Level (for 2 fridges): |  | watts.