The selection list shows the created rooms and configurable presets and areas, as well as the activities for the room or the whole installation.
These activities apply to all digitalSTROM Devices assigned to the room, i
ndependent of the application area (e.g. light or shade).
«Standby»The activity «Standby» can be triggered for a room when all lights are in the switched-off state (preset, area or device off) and a light push button is held for 2 s. The activity «Standby» can also be triggered at any time by 3 short clicks on the Off push button of the 2-way light push button (e.g. on the 2-way cable dimmer).
Therefore even digitalSTROM Devices with other colours (e.g. magenta for video) can be switched off with all push buttons independent of the application area. For example, you can use the Wipe mode of the room push button to switch off the TV and put it into its own standby mode after turning off the room lighting.
For more information on this subject, refer to chapter 5.3.2.
«Deep off»The activity «Deep off» can be triggered for a room when all lights are in the switched-off state (preset, area or device off) and a light push button is held for 3 s. The activity «Deep off» can also be triggered at any time by 4 short clicks on the Off push button of the 2-way light push button (e.g. on the 2-way cable dimmer).
For example, this allows you to completely turn off the TV connected to a digitalSTROM inline adapter.
digitalSTROM Device
s switched off by the activity «Deep off» are switched on again if:
These activities apply to all digitalSTROM Device
s in the digitalSTROM installation independent of the application area (e.g. light or shade). digitalSTROM Devices triggering higher-level activities can be installed in any room. Higher-level activities are triggered independent of the room.
The actuation for 3 seconds of a push button configured as "Leaving home button" triggers the activity «Leaving home». Most digitalSTROM Devices will be switched off. The desired behaviour can be configured as necessary.
For example, you can switch on devices connected with a digitalSTROM inline adapter
. For this purpose the digitalSTROM inline adapter
must be configured in the operating mode Saving. See also chapter 5.3.2.
The actuation of a digitalSTROM push button configured as "Panic button" transmits the command «Panic» to all digitalSTROM Devices. Any digitalSTROM terminal block can be configured to either react to this activity or to ignore it. In the factory setting of the digitalSTROM terminal block the activity «Panic» turns on all lamps and opens the shutters/blinds.
«Rain»An external rain monitor reports the onset of rain or hail to the digitalSTROM System. With it, e.g. shade systems can be retracted or skylights closed.
«Hail»Based on weather data, external service providers generate weather warnings which prevent potential damage events. Thus online weather services can report e.g. the onset of hail to the digitalSTROM System. With it, e.g. shade systems can be retracted or skylights closed in good time.
«Fire»An external
smoke detector reports that a smoke development has been detected to the digitalSTROM System. With it, the activity «Fire» can be set back with 1x click on the Panic or Leaving home push button.
Higher level activities for groups
A command is transmitted to all digitalSTROM Devices to activate the current device value for the selected activity/preset
in the digitalSTROM Device.
Use this command to reset digitalSTROM Device
s to the last issued device value unless it was changed retroactively e.g. by actuating a room push button. As a consequence you can for example after activating the activity Panic directly restore the lighting preset
without activating presets or resetting dimmer values.
Note on motion commands and presets for shading systems